Custom Light kit for Custom Batmobile
Light components Only, No Lego set, pieces or minifigs included
Additional lego pieces required for installation & Not included
Mini light kit includes:
- 1 Mini module
- 1 CR1225 battery
- 8 white lights (4 LED wires)
# of lights in this custom Batmobile:
- 2 Headlights
- 2 Taillights
- 2 Exhaust/Flames
Lego pieces required for modificaiton (not included)
- 1 black 2x4 plate
- 2 black 1x2 brick with 2 holes
- 1 trans-orange (or clear) round 2x2 boat stud
Installation Instruction Photos
Change 4x4 black plate to 2x4 black plate.
Insert 1 LED first through the hole behind the blue pin.
Insert the 2nd LED.
Pull wire up until male connector can attach to the control module.
All goes well, it should look like this.
Front Headlights
Replace the black 1x2 brick with a black 1x2 brick with 2 holes.
Insert 1 LED at a time through the left, inner hole.
Remove the 2 stacked 1x2 gray plate.
Add on the top cover and gap the LED toward the front headlight.
If you don't get it the first time, try adjusting the LED bulb.
Push the wire up and tuck underneath the cover as far in as possible before adding back the wheel.
Taillights
Tie the wires in 1 loop to shorten the length.
Insert bulb through the gap opening to the taillight.
Insert the bulb into the hole behind tail light. The 1x2 black brick will hold the light in place.
Side View
Front side view
Move the gray bracket plate 1 notch left or right.
Add on exhaust piece with LED bulbs placed inside.
Use a tran-orange round boat stud Lego piece holds the flames in place (trans-clear will work too)
Lightly push the module all the way down.
All goes well Batman will still fit nicely inside.
Ready to ride!!
Post new comment